Subject: Two new youtube videos
From: Rotary Engine
Date: 4/21/2008, 5:35 AM
To: AAA Put this in the To box


I sent an email in on advice for a rotory engine on a Cougar/Tailwind,
Does it take a while for it to go through or do I have to get approved
first?

Also in doing some more research I saw that a Walter Williams was
building a 125 hp single rotor turbo. Is this doable?

Dan

Certainly doable but not cheap :) One rotor Mazda based engines tend to
cost more
than 2 rotor Mazda based engines as certain major parts like the e-shaft
must be custom
made. Rotamax can probably sell you a two rotor NA with about the same HP
and weight
for just a little more money.


Paul Lamar ...No rotor no motor.

Dan,

I'm working on a single rotary engine for the Vision, now the Vision is
composite low wing but I believe a lot of design was borrowed from the
Tailwind.
I gave Walt some info on the single crank ( E-shaft) a while back but I'm
unsure at what stage he's at. Paul is correct about the possible cost's, I
haven't been able to find anyone that would produce single e-shafts for a
reasonable cost so I'm turning up my own. It's looking pretty good so far.

Larry also said he would do these in the future if enough people were
interested - he's the CNC man.

It will probably cost me about $500 all up for the crank, That's material,
grinding, heat treatment. I'm hoping for
125 hp with a Renesis rotor (10:1 compression).

Hope that helps - see photo of the partly turned crank.
I might be slow but I'm rough!
George (down under)



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.