Subject: Two new youtube videos
From: Rotary Engine
Date: 4/21/2008, 9:28 AM
To: AAA Put this in the To box


   Dan,

   I'm working on a single rotary engine for the Vision, now the Vision is
   composite low wing but I believe a lot of design was borrowed from the
   Tailwind.
   I gave Walt some info on the single crank ( E-shaft) a while back
   but I'm
   unsure at what stage he's at. Paul is correct about the possible
   cost's, I
   haven't been able to find anyone that would produce single e-shafts
   for a
   reasonable cost so I'm turning up my own. It's looking pretty good
   so far.

   Larry also said he would do these in the future if enough people were
   interested - he's the CNC man.

   It will probably cost me about $500 all up for the crank, That's
   material,
   grinding, heat treatment. I'm hoping for
   125 hp with a Renesis rotor (10:1 compression).

   Hope that helps - see photo of the partly turned crank.
   I might be slow but I'm rough!
   George (down under)


That looks very interesting, Once I get into this a little more I may be
able to turn one of those myself. The A&P I work for has a big lathe
like the one in your photo.

Dan

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.