Subject: Two new youtube videos
From: Rotary Engine
Date: 4/21/2008, 3:47 PM
To: AAA Put this in the To box

    Dan,

    I'm working on a single rotary engine for the Vision, now the Vision is
    composite low wing but I believe a lot of design was borrowed from the
    Tailwind.
    I gave Walt some info on the single crank ( E-shaft) a while back
    but I'm
    unsure at what stage he's at. Paul is correct about the possible
    cost's, I
    haven't been able to find anyone that would produce single e-shafts
    for a
    reasonable cost so I'm turning up my own. It's looking pretty good
    so far.

    Larry also said he would do these in the future if enough people were
    interested - he's the CNC man.

    It will probably cost me about $500 all up for the crank, That's
    material,
    grinding, heat treatment. I'm hoping for
    125 hp with a Renesis rotor (10:1 compression).

    Hope that helps - see photo of the partly turned crank.
    I might be slow but I'm rough!
    George (down under)


That looks very interesting, Once I get into this a little more I may be
able to turn one of those myself. The A&P I work for has a big lathe
like the one in your photo.

Dan

Dan,
That's Cheap Chinese lathe, a big lathe would be great - CNC would be
wonderful.
George ( down under)

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.