Subject: Two new youtube videos
From: Rotary Engine
Date: 4/21/2008, 5:47 PM
To: AAA Put this in the To box

    > Dan,
    >
    > I'm working on a single rotary engine for the Vision, now the Vision
    > is
    > composite low wing but I believe a lot of design was borrowed
   from the
    > Tailwind.
    > I gave Walt some info on the single crank ( E-shaft) a while back
    > but I'm
    > unsure at what stage he's at. Paul is correct about the possible
    > cost's, I
    > haven't been able to find anyone that would produce single e-shafts
    > for a
    > reasonable cost so I'm turning up my own. It's looking pretty good
    > so far.
    >
    > Larry also said he would do these in the future if enough people were
    > interested - he's the CNC man.
    >
    > It will probably cost me about $500 all up for the crank, That's
    > material,
    > grinding, heat treatment. I'm hoping for
    > 125 hp with a Renesis rotor (10:1 compression).
    >
    > Hope that helps - see photo of the partly turned crank.
    > I might be slow but I'm rough!
    > George (down under)
    >
    >
    > That looks very interesting, Once I get into this a little more I
   may be
    > able to turn one of those myself. The A&P I work for has a big lathe
    > like the one in your photo.
    >
    > Dan

   Dan,
   That's Cheap Chinese lathe, a big lathe would be great - CNC would be
   wonderful.
   George ( down under)


This one is not Chinese but it is a big old thing not CNC. I do have
access to a CNC machine from a fellow EAA member. At least I think it is
it has a computer panel.

Dan

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.