Dan,
Big old manual is good, the grinders do the finishing work. The
smaller
lathe has some flex in the tail-stock, due to the eccentric. Leave
20 th.
for finishing.
George ( down under)
Did you just use a two rotor shaft as a pattern or do you have a set of
plans?
Dan
Dan,
I drew my own plans, but basically you copy off the 2 rotor shaft. The bit
that might get some people is that the front end of the shaft including
rotor lobe is superimposed on the rear rotor lobe - which puts the front
keyway slot on opposite side to the rear keyway slot. This then puts the
counterweights on the same side ( and not opposite as in the 2 rotor).
There is no rocking couple in the single rotor so all counterweights counter
balance the ONE rotor lobe.
As Richard Sohn suggested this also makes the static balancing very easy as
well. How that relates to dynamic balancing is still up in the air for me -
as I haven't done one yet, although I don't envisage any problems. There is
the dilemma of what to include in Dynamic balancing, but that will come out
in the wash.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.