Dan,
I have spoken to Francois as to why he didn't consider the PP, he
suggested
for longevity reasons - the harder you run any engine the shorter the
TBO -
Mistral is looking at 3,000 hrs TBO. As we only use the high HP for
take-off
and climb, I can't see that making the TBO shorter, but I'm not the
expert.
I should imagine Turbo making the TBO shorter as well.
Design your motor around your power needs and weight on FWF restrictions ;
is my design philosophy. 160 -180hp NA ( side port), 200 on PP and 250 hp
on Turbo, is my guess, but Paul would have a better handle on those
figures.
I only need 115 to 125 hp ( at max of 300 lb FWF), so that's what I'm
concentrating on. The two rotor is a little heavier at 340 lbs and has too
much hp ( for my immediate needs), so I go for the single at approx 270
lbs
(guesstimate) and maybe 125hp (with a bit of luck).
George (down under)
Unfortunately, I've been so busy at work for the last 6-7 months that
I've had to delay my Turbo 20B project, but I'm now back in the saddle
and ready to start sourcing parts. I've decided to definitely pursue
the P-Port configuration, but I'm not willing to attempt making the
P-Ports myself. What are my options for sourcing well make P-Port
Housings? I can't buy direct from Mazda. Racing Beat has some, but I
don't know which housings to buy for the 20B. They also list both Turbo
and Non-turbo housings. If I buy turbo housings and later decide to
change to NA, do I have to buy new housings? Whats the difference??
Don
Larry Childs said he can make the holes in the rotor housings quickly.
You can ship him your rotor housings he can bore the holes on his NC
mill using a custom jig and send them back. You tig weld them in or
have somebody do it for you. It is real easy.
I am thinking of sourcing a bunch of 2 inch SS tubes from Larry made on
his 5 axis NC mill
and selling them on here near cost for those that want them. The tubes are
rather time
consuming to make by hand. I will do a batch and when those are sold out I
will
pause for awhile and do another batch when the demand increase.
Our youtube video on How to P-Port the RX8 engine has been very popular
judging
on the rate of hits we are getting. There must be dozens of P-port engines
being
built for the racer market. We have had over 1000 hits so far.
http://www.youtube.com/watch?v=LkKw72dZ2yc
Paul Lamar
Dan,
The more power a housing is designed for the bigger the ports are, so the
turbo exhaust port would ( I expect) to be the biggest , the next biggest
is the Cosmo ( I think). Apart from that there's very little difference
between housings. There are differences between different models in regard
to where the oil injection ports are, and exhaust inserts, but that's about
all. You want the biggest exhaust ports as you want the housing to breath as
well as possible, especially with PP.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.