Subject: prop question for the group
From: Rotary Engine
Date: 4/26/2008, 10:06 AM
To: AAA Put this in the To box


This is not directly related to rotary engines, except that it's
connected to one.



I just received my prop from Catto, it's a beaut, but I have a problem.
The backing plate, where the prop contacts the prop hub, is aluminum. My
spinner and it's rear bulkhead is made from carbon fiber. Aluminum in
direct contact with carbon fiber is a no-no. I was thinking of applying
RTV between the bulkhead and prop just before I install it and torque
the bolts down. This would theoretically insulate the aluminum backing
plate on the prop from the carbon fiber spinner bulkhead, but I worry
that it would mess up the friction between the prop and the spinner
bulhead. Any suggestions about how to approach the problem of insulating
the these two components from each other in such a way as to not  do
something bone- headed?



Brian Trubee


The usually way is use a thin layer of fiber glass on the carbon fiber to electrically insulate
the aluminum to the carbon fiber interface. I also think titanium does more or less
the same thing. Paint the bolts with a thin layer of epoxy paint.

The spinner itself has very little torque on it so friction is not a problem
on the outer spinner bulkhead.

It is a problem if the aft spinner bulkhead is between the prop and the PSRU flange.
In that case I would make an aluminum spinner bulkhead or contact Catto for their
recommendations.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.