Subject: Source for P-Port Rotor Housings
From: Rotary Engine
Date: 4/27/2008, 9:54 AM
To: AAA Put this in the To box


   Paul,
   I'd like a set of Tubes for my 20B.
   Don Mitchell


   http://www.youtube.com/watch?v=LkKw72dZ2yc


   I'll have a talk with my supplier.

   --
   Paul Lamar ...No rotor no motor.


Paul,

How does the engine run at idle conditions with p-port intakes and side
port exhausts? Same overlap problems? Does this also use the side ports
as well?

Rob

It really does not matter much for aircraft service as you must run the RX7 engine
above 2000 RPM anyway to avoid a resonant condition in the PSRU. With a
2.85:1 gear box ratio the prop RPM is 700. About the same as a direct drive
piston engine.

With the RX8 engine version of the P-port the engine idles
pretty much the same as the stock RX7 engines as the RX8 engine side exhaust remains.
The RX7 had side intake with peripheral exhaust and the RX8 P-port is
just the opposite. Peripheral intake and side exhaust. The breathing of any
intermittent combustion engine is far more affected by the intake breathing
compared to the exhaust breathing.

Why is this so? The pressure differences that cause the gases to flow in the
first place are much lower on the intake side. Therefore you
need large diameter smooth intake tubes with as few bends as possible.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.