Subject: Source for P-Port Rotor Housings
From: Rotary Engine
Date: 4/27/2008, 11:15 AM
To: AAA Put this in the To box



    Paul,
    I'd like a set of Tubes for my 20B.
    Don Mitchell


    http://www.youtube.com/watch?v=LkKw72dZ2yc


    I'll have a talk with my supplier.

    --
    Paul Lamar ...No rotor no motor.


    Paul,

    How does the engine run at idle conditions with p-port intakes and side
    port exhausts? Same overlap problems? Does this also use the side ports
    as well?

    Rob

    It really does not matter much for aircraft service as you must run
    the RX7 engine
    above 2000 RPM anyway to avoid a resonant condition in the PSRU. With a
    2.85:1 gear box ratio the prop RPM is 700. About the same as a
    direct drive
    piston engine.

    With the RX8 engine version of the P-port the engine idles
    pretty much the same as the stock RX7 engines as the RX8 engine side
    exhaust remains.
    The RX7 had side intake with peripheral exhaust and the RX8 P-port is
    just the opposite. Peripheral intake and side exhaust. The breathing
    of any
    intermittent combustion engine is far more affected by the intake
    breathing
    compared to the exhaust breathing.

    Why is this so? The pressure differences that cause the gases to
    flow in the
    first place are much lower on the intake side. Therefore you
    need large diameter smooth intake tubes with as few bends as possible.

    Paul Lamar ...No rotor no motor.

So in a road engine an RX-8 p=port stand to gain what kind of hp over
the stock one throughout its entire rev range?

Rob Woods


300 HP or more at 10,000 RPM or so with a Teflon slide throttle.
My guess. Maybe a little less due to the side exhaust port.
Ironically it could be achieved and still pass the current
smog rules using a trap door P-port.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.