Prices are:
$20 bucks each for the tubes.
Bore your housings cost $100. We can supply new ones at competitive
prices if you need new housings.
We will do it all for $250 each for your housings. Tig weld the tube to the liner,
grind and finish polish. This is not that hard to do yourself.
Just be careful not to scratch the chrome. Just about any competent
tig welder can weld in the tubes. We have had three different welders do
it so far and none of them had any trouble. You save a lot of time by having
the pre contoured SS tubes.
See Paul's video at
http://www.youtube.com/watch?v=LkKw72dZ2yc
The housings must pass inspection for chrome, corrosion & size before I will accept
them for mod. Payment can be arranged to go direct here using Paypal, then I just
email you an invoice. Work it just like ebay. When the money is
transferred, we ship. I will have Tammy work on setting up to take Visa and
Mastercard as well. I can take credit cards now, but the statement will come
up as HMS electronics.
I will order a 20ft length of tubing and get it cut up for the 8.64 strait
cut profile. I will leave 1 inch sticking out of the housing.
We have Don in Texas waiting for the prices and he is sending housings.
Anyone needing new housings, use the Mazdatrix housing prices. Save some
money on shipping. Simple hose clamps will attach the slide throttle
so the engine can be disassembled very fast.
Even with new housings, these will be a lot cheaper than going to racing
beat housings.
A dual carb and slide throttle combination is on the way for a good idle
and lots of power. Somewhere between 240 HP and 260 HP. Anyone can understand it
and fix it. The closer the slide throttle is to the rotor housing the better
the P-port idle. This cuts down the amount of exhaust gases getting into the intake
at low RPM.
On the RX8 engine, a new idea is to run the side and p port exhaust using the older p-port
exhaust rotor housings with the O-ring slot in the rotor housing just like the RX8 rotor housings.
Be a great way to reduce exhaust back pressure without any port work. It's fun food for
future stuff to try. Besides, everyone would scratch their head looking at a
5 port header! Just an idea only at this point.
Larry
Larry Childs
<larry@designitprototype.com>
http://www.designitprototype.com/
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.