Subject: prop question for the group
From: Rotary Engine
Date: 4/28/2008, 10:00 PM
To: AAA Put this in the To box



      >(At least for some applications) I recall Brian Alley (composite
guru,
      >pro Lancair builder) says that anodizing provides adequate galvanic
      >protection for certain applications..  Is the aluminum anodized?
      >Probably not..  I'd add one layup of thin fiberglass to the side of
      >the spinner backing plate that contacts the prop's drive side.  It
      >doesn't take much to keep the carbon fibers from making direct
    contact
      >with the aluminum.

      >Get some of the very light weight, fine weave fiberglass cloth from
      >the hobby store.  It's relatively easy to work with.  And some slow
      >cure resin/hardner.  Have you worked with fiberglass much?

      >I imagine that your setup uses drive lugs in the output flange?  I
      >think the dependence friction to transmit the torque loads is lower
      >than when just mating the prop to a flat flange.  The diameter of the
      >drive lugs can be much larger than the bolts, and so can handle the
      >shear loads much better.

      >RTV would not be my choice.  I suspect it would eventually cause you
      >headaches with prop tracking - especially after being removed and
      >installed a few times - the RTV will wad-up.  It's not structural
      >(soft).


      >Regards,

      >Matt-

    Hi Brian,
    Something didn't sound right about sandwiching ANYTHING between the
    prop flange and the drive flange, so I went out to my workshop and
    looked at my Hartzel props. Sure enough the spinner bulkhead is attached
    to the OD (outside diameter) of the prop flange. Its an elaborate setup
    but, the bottom line is there is DIRECT CONTACT of the prop flange and
    the drive flange, no bulkhead, no RTV, no aluminum disks, no carbon
    fiber or fiberglass. I have 2 props --a 2 blade & a 3 blade-- both are
    done the same. Hope this helps.       Dave M


 Dave,

 Would it be possible to send a photo?



 Thanks,

 Brian Trubee


 Your prop backing plate may already be anodized, but if not it is easy
 enough to do. Google "anodize" and follow the simple instructions. Karibian


My understanding was that the prop had an aluminum plate embedded into
its structure.  It would have been easy to anodize it before building
the prop, but not it's monolithic with the wood and composite..

Matt-

The main problem is the six 3/8 bolts will put far more compressive
load on the epoxy than it can take. The best thing is mount the aft carbon fiber
spinner bulkhead as Dave M suggest.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.