Hello Pual,
I am looking for a dwg of the IO540E Lycoming that has the C of G on.
I and designing a new mount to take the Rotary and would like to
improve the balance it possible. They give a dry wieght of 368 lbs
dry. This assume they have starter and alternator on. It would be great
to get any feed back on this subject. I have done many exercise oh the
rotary so have everything I need there.
Thanks all
--
Best regards Don,
ddunbar
mailto:ddunbar@echidna.id.au
That sounds low.
Here is what I have on the weights.
O-540-A1A5 396
O-540-B2B5 395
O-540-B4B5 395
O-540-B4B5 398
IO-540-A1A5 437
IO-540-C4B5 402
IO-540-D4A5 402
IO-540-E1A5 437
IO-540-G1A5 443
IO-540-J4A5 409
IO-540-K1A5 470
Here is some dwg data from Bill Jepson as well.
The CG's are a good question. I don't have an answer for.
Paul Lamar ...No rotor no motor.
Hi Don,
Some time ago, when I thought airplane engines needed pistons, I saw a
picture that I think was somewhere on the Lycoming website. It showed
clearly a metal inverted "U" lifting ring attached to the centerline
mating case flanges. That lift ring should be very close to the CG. If
you can find that pix and count the bolts then count the bolts on any
"to scale" drawing you can get a good idea of the longitudinal CG.
(Vertical CG -no idea) Dave M
Just checked the back page of Sport Aviation mag and Superior Air Parts
ad shows the ring position for 4 banger, but it shows you what to look for.
Great Idea Dave. My Cont. O-470 has one of those lifting clips.
Here is a Kitplanes article on the subject.
BTW the bare two rotor 13B is 200 pounds and a 3 rotor 260 pounds
less all manifolds and acc. such as starter, water pump,
turbo charger and alternator.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.