Subject: Rotary powered Berkut O-540 eng wt.
From: Rotary Engine
Date: 5/1/2008, 9:54 AM
To: AAA Put this in the To box


 Hello Pual,
 I am looking for a dwg of the IO540E Lycoming that has the C of G on.
 I and designing a new mount to take the Rotary and would like to
 improve the balance it possible. They give a dry wieght of 368 lbs
 dry. This assume they have starter and alternator on. It would be great
 to get any feed back on this subject. I have done many exercise oh the
 rotary so have everything I need there.
 Thanks all


 --
 Best regards Don,
  ddunbar                          mailto:ddunbar@echidna.id.au

 That sounds low.

 Here is what I have on the weights.
  O-540-A1A5 396
  O-540-B2B5 395
  O-540-B4B5 395
  O-540-B4B5 398
 IO-540-A1A5 437
 IO-540-C4B5 402
 IO-540-D4A5 402
 IO-540-E1A5 437
 IO-540-G1A5 443
 IO-540-J4A5 409
 IO-540-K1A5 470

 Here is some dwg data from Bill Jepson as well.

 The CG's are a good question. I don't have an answer for.

 Paul Lamar ...No rotor no motor.

 Hi Don,
 Some time ago, when I thought airplane engines needed pistons, I saw a
 picture that I think was somewhere on the Lycoming website. It showed
 clearly a metal inverted "U" lifting ring attached to the centerline
 mating case flanges. That lift ring should be very close to the CG. If
 you can find that pix and count the bolts then count the bolts on any
 "to scale" drawing you can get a good idea of the longitudinal CG.
 (Vertical CG -no idea)       Dave M
 Just checked the back page of Sport Aviation mag and Superior Air Parts
 ad shows the ring position for 4 banger, but it shows you what to look for.


 Great Idea Dave. My Cont. O-470 has one of those lifting clips.
 Here is a Kitplanes article on the subject.

 BTW the bare two rotor 13B is 200 pounds and a 3 rotor 260 pounds
 less all manifolds and acc. such as starter, water pump,
 turbo charger and alternator.



 Paul Lamar ...No rotor no motor.


Hey cool!  I had wondered whether the lift loop was located to keep
the engine level with or without the prop attached, and I guess these
pics answer that question..  :)  If you need it to balance with the
prop, probably could just move the loop to one of the bolts closer to
the nose..


Matt-


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.