Hey everybody,
A friend and I are building a Velocity. We want to use the Mazda Rotary
but we're not sure which one to get.
Mark Pascall
N31PK
If it were an XL I would use a 3 rotor.
The regular Velocity works fine with a two rotor.
Especially a two rotor P-port like this one.
Top speed is well over 200 MPH.
Paul Lamar ...No rotor no motor.
Thanks for the reply.
Its a ten year old 173. Are all 2 rotors created equal?
Mark
N31PK
More or less everything after 1989 is pretty much equal.
There are minor improvements here and there. The 10:1 compression ratio
in the RX8 engine is a slight advantage in fuel consumption I suspect.
Also the water pump is a bit lighter and lower profile.
The 3rd gen turbo engine 1992 to 2004 is a bit beefier but not too useful
unless you turbo.
If you buy an engine in a junkyard make sure it has not sat outside
as getting water inside the engine can rust the end housing wear surfaces.
Mazdatrix in Signal Hill does an excellent job of overhauling an engine.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.