I've read not to allow CF epoxy to be in contact with aluminum. Is that
true? What if you do a wet lay-up with the epoxy carbon fibber over the
aluminum ? Or, if completely true, will it work if you put a single
layer of e-glass over the aluminum first ?
-dave A
Hi Dave,
The info you read is correct. If direct contact between the carbon
fibers and the aluminum occurs and moisture gets there also a battery is
created and galvanic corrosion will eat the aluminum. Remember that air
always contains some moisture--even in sunny SoCal (albeit very little :
). Pure water is non-conductive, but rain water contains many conducting
contaminates. The trick is to electrically isolate the components from
one another. A cork gasket or coating of RTV if you're careful not to
squeeze it all out of the joint, will work. If you are trying to do a
wet layup and using an aluminum radiator as a form, mask the rad, then
start the layup with a layer of GLASS then go to your carbon fiber. As
years of vibration destroy the epoxy, the GLASS will come into contact
with the aluminum, not the carbon. The most common construction mistake
is inserting fasteners ( like aluminum rivets ) thru a carbon fiber
part. You need to provide an isolating sleeve, usually a piece of thin
wall nylon tube the length of the hole is inserted before the rivet.
Hope this answers your question. Dave M
If you need the layups to structurally bond with the aluminum:
I wonder if a good anodizing or anodized layer on the aluminum is sufficient
to prevent the galvanic corrosion.
How about a good epoxy base coat prior to the carbon layup?
Mike McGee
RV-4 in pieces, Hillsboro, OR
Mike & Diana
..at large somewhere on the planet..
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.