Hi Paul,

I got my single rotor parts back from PY, unbalanced. Now I have to
start it over again.

I talked to a guy at Mazdatrix, and he confirmed that they could do it.
Do you think they can work the non stock configuration I have? Just like
to hear your opinion.

If I decide to go with them, would it be possible for you to keep an eye
on them if necessary?

Just finished a couple of casting patterns for the front side housing
and oil pump cover. I think I found a suitable magneto ignition with an
inside magnet rotor. This would make it a really simple engine.

More later.

Richard Sohn
N2071U

Yes I keep and eye on Mazdatrix all the time :)
They don't make a move without my approval :)

Did you say it was a one rotor when you talked to Mazdatrix?
They farm it out to another guy here in so cal so you might need
to talk to him directly. I'll send this to Dave Lemon.
Perhaps he can put you in touch with the guy that actually does it.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.