As far as I can tell there is no HP limit on Light Sport Aircraft by the
FAA. Just a 120 Knot CAS maximum speed limit and a maximum take off
gross weight
limit of 1320 pounds. A stall speed without movable flaps of 45
knots. There is no
range limit.
This has several possible scenarios.
One could limit the speed by setting the prop pitch and diameter to such
that the airplane cannot exceed the limit yet still have good takeoff
performance.
One could add to the payload or range if one had a lighter weight
engine.
The standard engine is the 100 HP Rotax 912S which weighs 136 pounds
with PSRU and all accessories except radiator. Hard to beat. A Cont.
O-200
is at a disadvantage at around 200 pounds.
One could add wing area or fixed slats and/or flaps (drag) and HP to
get a
shorter field takeoff capability yet not exceed the WOT 120 Knot
CAS. A large diameter,
low pitch prop would generate more static thrust and act like a rev
limiter to limit top
speed. In other worlds build a super STOL.
The Ultra Light rules still apply for powered airplanes.
The U.S. FAA has a separate definition of ultralight aircraft
defined in FAR
103. Aircraft falling within the U.S. ultralight specifications are
extremely
lightweight (less than 254 pounds [empty] if powered, or 155 pounds
[empty] if
un-powered), are intended for
manned operation by a single occupant, have a fuel capacity of five U.S.
gallons or less, a maximum calibrated airspeed of not more than 55
knots,
and a maximum stall speed of not more than 24 knots. Ultralight aircraft
in the U.S. do not require pilot licensing, medical certification, or
aircraft registration.
You will need a super light weight high power to weight ratio rotary
engine
indeed for this category. The AIXRO Kart engine appears to be ideal
right at the
moment. Two cycle piston engines are hard to beat for this category.
Fuel
consumption is not a real issue as these airplanes are pure toys.
Does anybody have the ASTM rules or standards? I don't want to pay
for them?
:)
--
Paul Lamar ...No rotor no motor.
Paul,
The ASTM rules are various and many from the aircraft manufacturer
document
of 600 pages to some of the ECU standards of 10 plus pages.
Let me see if I can get you some information.
Eric Barger, President
Phone 419-694-3000 x 222
RotaMax Inc.
15152 Twp Rd 190
Arlington, OH 45814
Fax 419-694-1401
www.rotamax.net
Thanks Eric.
--
Paul Lamar ...No rotor no motor.
You as a builder set the max cruise on an experimental plane. All you
need to do is set and placard the max cruise speed at 120 kts and you
are good to go. Just documentation is all that is needed. You are just
de-rating the performance. This is also done on production aircraft as well.
Dan
Experimental is an entirely different category from LSA and ultralight
as far as the FAA is concerned. Anything goes.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.