Subject: Which one should I get?
From: Rotary Engine
Date: 5/11/2008, 12:54 AM
To: AAA Put this in the To box


Hey everybody,

A friend and I are building a Velocity. We want to use the Mazda Rotary
but we're not sure which one to get.

Mark Pascall
N31PK

If it were an XL I would use a 3 rotor.
The regular Velocity works fine with a two rotor.
Especially a two rotor P-port like this one.
Top speed is well over 200 MPH.

Paul Lamar ...No rotor no motor.


Thanks for the reply.

Its a ten year old 173. Are all 2 rotors created equal?


Mark
N31PK

More or less everything after 1989 is pretty much equal.
There are minor improvements here and there. The 10:1 compression ratio
in the RX8 engine is a slight advantage in fuel consumption I suspect.
Also the water pump is a bit lighter and lower profile.

The 3rd gen turbo engine 1992 to 2004 is a bit beefier but not too useful
unless you turbo.

If you buy an engine in a junkyard make sure it has not sat outside
as getting water inside  the engine can rust the end housing wear surfaces.

Mazdatrix in Signal Hill does an excellent job of overhauling an engine.
-- 
Paul Lamar ...No rotor no motor.


Speaking of junkyards. Can you give some basic advice about what to look for
in a suitable candidate? I want turbo so how about the 13B TT or the 20B
turbo? Should it be from an automatic or a stick? Does it need to come with
a brain or does that get replaced anyway?

Thanks

Mark
N31PK

The 2nd gen turbo 1990 1991-1992 are best.
The exhaust manifold cracks but not as bad as the 1987-1989 2nd gen turbo's manifold.
Therefore I would stay away from the 87 88 to 89 turbo motors unless you are converting
them to normally aspirated (NA). It is really best to buy a running car.

The third gen turbo's 1993 to 2004 are not suitable as turbo aircraft engines
with out changing the exhaust manifold and the dual sequential turbo's out
for something like a TO4. The engine itself is rather bullet proof at up to 280 HP stock.
Especially with new 2 piece Mazda apex seals. Stock was Mazda 3 piece apex seals
which were quite fragile. Replacement seals from Mazda are now 2 piece.
Be real careful buying after market apex seals as there is some real junk out there.
Please read this:  http://www.rotaryeng.net/seals.html

If you convert them to normally aspirated  you will probably want higher
compression rotors. I don't know what the situation is running high compression
(10:1) RX8 rotors. I suspect it is possible but I have no feedback on that yet.

The 20B is in the same situation. You will need to swap out the turbo's
exhaust manifold and dual sequential turbos. Of course you might find a short block
or a 20B made up from mostly 13B parts.

The RX8 engine is good as is for normally aspirated. Just check it for accident damage.

Of course they all required custom intake manifolds. I recommend not fooling around with side ports. It is almost cheaper to P-port than build an intake manifold for a four or six port RX8 motor. You will get more power and a lower fuel burn.
It is really easy to screw up the design of a side port manifold.

Paul Lamar ...No rotor no motor.


Thanks Paul for all your advice.

Mark Pascall

-

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.