Subject: Fuel burn and speed
From: Rotary Engine
Date: 5/19/2008, 11:15 AM
To: AAA Put this in the To box


   BTW Al Gietzen just told me his 3 rotor Velocity would do 175 Kts
   (200 MPH)
   on 9 gallons an hour.

   http://www.rotaryeng.net/final-cut2-Al-Gietzen-Velocity.wmv

   If this Cozy with retracts can do the
   same that would be a range of about 1300 miles with this
   three tank system. 9 gallons an hour at a BSFC of .5
   is only 108 HP or 33% power level with a 300 HP engine.
   In Al's case it is about 50% power. Top speed is the
   cube root of HP so Al's top speed is:

   Cube root of 108 HP is 4.76.
   200 = k X 4.76
   k = 200 MPH/4.76 = 42 = drag constant for Al's airplane.
   Cube root of 225 HP is 6.
   So Al's top speed in theory with 225 HP is 252 MPH.
   Fuel burn at .6 BSFC full rich could be as high as
   23 gallons per hour.


   Rick's top speed with the same drag as Al's is:
   Cube root of 300 HP is 6.7.
   6.7 x 42 is 281 MPH.
   So Rick's top speed in theory is 281 MPH with 300 HP.
   Fuel burn at .6 BSFC full rich could be as high as
   30 gallons per hour.

   What fuel burn and speed are you cruising at Perry?

   --
   Paul Lamar ...No rotor no motor.


I have a stock 86 two-rotor, spec is 146HP at 6500 RPM and I'm pretty
sure that is about what it's putting out based on prop analysis
predictions being consistent with actual results.

There is some data from my last long trip to Kansas at
http://www.mickaircraft.com/k61_2/k61_2_photos.htm

Cruise is 165 knots at 9 gph, running rich best power, no leaning.

Perry



KMMV-KLGU approx. 35 gal., 3.6 hours, 570 nm, WOT
at 11,500 feet, 6300 engine RPM, 2900 prop RPM >> 9.7 gph, 16.3 nm/gal,
18.7mpg, 158 knot [180 MPH] average ground speed.

Lets see say 70% power at 11,500 or 102.7 HP
9.7 gallons an hour or 58 pounds per hour.
58/102.7 or about .56 BSFC.
Not bad Perry for no leaning. Stock Mazda 2nd gen CPU.

That is also probably  near top speed.

Cube root of 102.7 HP is 4.68

180 MPH = k x 4.68

180/4.68 = 38 = k

K = 38 for the drag constant number which is lower than Al's.

That means your flat plate equivalent may be higher than Al's which makes
sense as you have fixed gear and he has retracts. 42/38 or 10% higher.
In other words you will go slower as
a function of the cube root of the HP.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.