Subject: Ryan E-racer ex Geroge Grahm
From: Rotary Engine
Date: 5/24/2008, 6:01 PM
To: AAA Put this in the To box

Ryan,

Here is what I suggest for a muffler.
The exhaust pipe bends are two inch OD to fit a Racing Beat exhaust flange.
Burns Stainless in San Diego.

321 SS .065 wall. The can is six inches 321 .065 wall but that might be too big
to fit. Try 5 inches. Make a foam mock up to see what fits in there. Put nothing
in the can. It will just melt and blow out anyway.

Also a small bump on the cowl won't hurt back here.

There are two SS 304 1.5 inch OD down pipes but you can use what you have cut down.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.