Subject: [Fwd: RE: Ryan E-racer ex Geroge Grahm]
From: Rotary Engine
Date: 5/25/2008, 12:03 PM
To: AAA Put this in the To box


Ryan,

Here is what I suggest for a muffler.
The exhaust pipe bends are two inch OD to fit a Racing Beat exhaust flange.
Burns Stainless in San Diego.

321 SS .065 wall. The can is six inches 321 .065 wall but that might be too
big
to fit. Try 5 inches. Make a foam mock up to see what fits in there. Put
nothing
in the can. It will just melt and blow out anyway.

Also a small bump on the cowl won't hurt back here.

There are two SS 304 1.5 inch OD down pipes but you can use what you have
cut down.
-- 
Paul Lamar ...No rotor no motor.


Paul,

Then the shape of the can does all of the work.
Do you have a photo of one already made.

Is there a web site for this group?

Thank you for the graphics,
Ryan

Jerry hey can build what you need.
Jerry Hey <jerry@jerryhey.com>
It is up to you to make sure it fits.
So I would ship him a foam mock up.

Here are some picture of various and assorted  tangential mufflers.
Web site is: http://www.rotaryeng.net

There are a lot more out there.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.