Subject: George Graham E-racer 's new intake manifold.
From: Rotary Engine
Date: 5/26/2008, 5:30 PM
To: AAA Put this in the To box

Hi Ryan,

Here are the transitions from oval to round I was referring to
and some 3D's and pics. on simple manifolds TIG welded out of tubing.
I would use a 2 inch OD .065 wall  on the outer two tubes
and 1.75 inch OD .065 wall on the inner two tubes.

The tubes should be about 28 inches long but a removable
center section of varying lengths would not hurt for
tuning purposes.

I would use a Ellison carb on the end of the 4 inch dia. round  plenum
facing forward if possible.

http://www.ellison-fluid-systems.com/

I would use the EFS-4-5 Throttle Body Injector

You might find one on E bay.

This is lower priority than cleaning up the aerodynamics.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.