Subject: Zenith 801 motor mount
From: Rotary Engine
Date: 5/26/2008, 11:26 AM
To: AAA Put this in the To box



   To service the bungees, would the bracket have to be removed and the
   rear of the engine supported?  That is the only downside I can see.
   And I don't know how big of a deal that is.    On the other hand,
    this solution is strong and light and has a good strut angle.  Jerry


       ---------------------------------------------------
       This is what I suggest. A couple of simple 4130 sheet metal .090
       thick brackets bolted
       to the lower channel and fire wall with 10-32 machine screws. It
       also picks
       up the 3/4 inch diameter bungee cord pin where all the landing
       gear vertical
       loads are applied to. That pin, with the aid of the bungee
       cords, supports the
       entire weight of the nose of the aircraft while on the ground or
       impacting
       the ground :)

       What do you think?

       Paul Lamar ...No rotor no motor.



Looks good, I like it. Servicing the bungee is a major undertaking in
any event; I don't see this making it much worse. It may even help, as
the brackets could be used as a leverage point to stretch the bungee
into position.

The bungee 'fills' the channel behind the strut completely, there's a
good chance of it rubbing against the screws during taxi. The screws
would need to be applied from the inside out, or maybe SS rivets could
be substituted.

--Kenny A.
http://websites.expercraft.com/kennya/


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.