Hi Ryan,
Here are the transitions from oval to round I was referring to
SNIP
This is lower priority than cleaning up the aerodynamics.
--
Paul Lamar ...No rotor no motor.
Hi Paul,
One of the pix in this posting shows the alternator riding "backwards"
from its normal orientation ( pix # Rb13b006.jpg ). This means the
cooling fan built into the alternator is turning the opposite direction
from its designed intent. Do you or anyone on here know if this will
lead to an overheating problem considering the high electrical demands
of EFI systems? Thanx, Dave M
I don't know.
Paul Lamar ...No rotor no motor.
Wouldn't it be easier to pull the engine and p-port it and then build
a new, simpler manifold? Could still use the Ellison with a p-port
and a plenum. Be less bulky to get proper runner lengths...
All this oval to round stuff is scary. ;)
Matt-
Yes but.
He does not want to spend the time and money to pull the engine and have it
rebuilt or ported. This manifold would be a simple bolt on. A lot more HP at cruise would burn
more gas and not improve the top speed or cruise speed that much. Cube root of the HP.
The takeoff and climb out would greatly improve but that is not what he needs.
That is adequate as is for where he flies out of.
He would get a MPG benefit if he added EGT's so the kludged
up auto carb could be leaned properly. At this point there are no EGT gages.
The same time and money cleaning up the aerodynamics would pay off in better MPG.
The lower cowl does not fit well and the cooling scoops are draggy.
There are no fairings on the gear leg to fuse junction and no wheel pants.
Here are some more detail shots of the airplane.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.