Paul, some time back you did some drawings for Joe Graham's long EZ
project. He wants the absolutely shortest S-beam that can be
fitted. I proposed an 18.5 inch between centers beam and he still
wanted shorter. I thought he was going to contact you, but I have not
heard a word. He sent me a deposit which I should either send back or
come up with an S-beam that fits his project. So that is the
question. What is the shortest S-beam that can be fitted? Would it
have to be fitted with stiffer Barry Controls due to the reduced
leverage?
Jerry
This is what I have so far. There are two issues. Heat in the rubber
bushings and clearance for the oil pressure fitting on the left side
of the engine.
--
Paul Lamar ...No rotor no motor.
Yes, I have those drawings. What is the length of that S-beam? Do
you think cooling air could (or should) be directed at the rubber
bushings? The rubber bushing can be removed to install a 90º fitting
and then reinstalled. That would put the bushing potentially within .
250 to .5 inches from hot oil. I am also concerned about effectiveness
of a short beam. I would really like to have a long EZ engine mount
to offer if it is possible. Jerry
I would make my own rubber bushings out of silicon rubber sheet
or special order from Barry.
The cowl will need a few bumps here and there anyway to clear
the turbo.
There are two possibilities on the mount. One with the fuse cut back
and one with out the fuse cut back.
I suggest the one with the fuse cut back.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.