Subject: gearbox to fit Mazda
From: Rotary Engine
Date: 6/5/2008, 12:10 PM
To: AAA Put this in the To box


Dear Sir or Madam,

http://www.autoflight.co.nz/reduction/distributors.php

Do you have a universal gear box that will fit a Mazda
engine. Either 2.47 or 2.95?
Does the output shaft rotate in the same direction as the engine?
Thanks.

-------------------------------------------------------------------------------

This could solve some Mazda installation problems with the 84 mm 3.31 inch off set.
The only drawback, other than the spur gear, is the reverse prop rotation I think.
That means your choice of props is limited. Durability and long life remain
to be seen.

The resonant frequency may be a bit high with certain props
but the rubber coupling can be had off the shelf with a lower durometer (softer).
It is similar to rubber couplings used in BMW and Mercedes drive shafts
and is therefore way over kill as far as strength is concerned.
Those engines can have as much as 600 foot pounds of torque out
of the gear box. We are dealing with only 160 to 200 foot pounds.
The manufacture of the rubber coupling is
http://www.centa.info/?show=products&c=&nr=32

The weight, less the bell housing, is quoted at 9 Kg or 20 pounds.

Cost is still in question.

Paul Lamar ...No rotor no motor.

Autoflight offers a box for the Mazda engine (rotary type). The
ratios available are 1.9, 2.2, 2.4 and 2.9-1. They are on an order
basis and at this time I have 3 on order, which means I could add
yours to the list this week.
Cost is $4000 plus shipping to you.
Output of the flange is counter of the engine (it is gear to gear).
I have attached a pic of a Mazda box long nose.

Ron Carr  www.ramengines.com

Thanks Ron. I will publish this info for all to see.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.