> A Piper Arrow powered by a prototype Mistral
> (
http://www.mistral-engines.com/ ) rotary aircraft engine crashed
> after the
> engine lost power following takeoff from Palatka Municipal-Lt. Kay
> Larkin
I did the collapsed muffler deal at Sebring years back. The Flowmaster
(big suitcase looking thing) had all of the baffles piled up against the
rear outlet. The muffler swelled up like a giant pillow and the power
dropped off to nearly nothing. It didn't hurt the engine at all and we
raced at West Palm Beach the next weekend.
Lynn E. Hanover
Since you brought up the subject Lynn it is time to revisit the proper way of welding
the exhaust pipes to the exhaust flange.
The weld must be around the inside of the flange and not on the outside.
Even better is to have a non welded ball joint where the pipe joins the flange
like this early Steve Beckham and Everette Hatch Power Sport configuration.
That allows the exhaust system to expand and contract without stressing the joint.
http://www.rotaryeng.net/flange-welding.html
------------------------------------------------------------------------------------
Well now we know it had something to do with the muffler.
When I first saw these pictures I did not pay too much attention
as I thought it was made from Inconel.
On hindsight I can see several mistakes made by Mistral. Some of which may be moot
if constructed from Inconel. It might work as is if constructed out of Inconel.
First, was the two pipes were welded on the wrong side of the flange.
http://www.rotaryeng.net/flange-welding.html
We had a rotary powered Velocity crash because of this.
Second, a lot of trouble went into building a slip joint into the two piece inner can
and then the two clips were rosette welded to the outer can defeating the purpose
of making the inner can two pieces. Also one EGT can be higher than the other so there
will be distortions.
I always tell people NOT to put ANYTHING into the inner can as it will melt
for sure. Heck my C182 spit its guts out of the can on the ramp at Valdez and the EGT's
are only 1400 F and not 1800 F. One of my pax saw it and freaked out.
I said; "Not to worry we don't need that part." :)
Tom Jordans Limo EZ back in 2003 had a similar muffler to this one. You could stand
behind the prop and look directly into the can at full chat through the down pipe.
The inner stuff was white hot... almost transparent. Only a matter of time for that
to melt and be spit out through the prop. It could have hit me in the eye and
blinded me. Stupid stunt.
Since most people do not want to pay a $1,000 or $2,000 for an Inconel muffler
make the hollow can out of .065 inch thick 321 SS and let it go at that.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.