Paul, Who is building the E shafts for the fabricated 3 ?
Maybe they'd like to build alum irons too. Thanks, Dave
On Sun, Jun 8, 2008 at 6:09 PM, Rotary Engine <
rotaryeng@earthlink.net
<mailto:rotaryeng@earthlink.net>> wrote:
Paul, What most practical length intake runners would be best on the 3
rotor turbo?
Can't do much about the exh length into the turbo.
Why is the extra iron wider on the 3, for additional bearing surface
area? Dave D
Any pipe with air flowing through it driven by a pulse source is tuned
at some frequency. The big question is: will the other side of the
compressor
see the pulses from the engine side? I don't know the answer to that.
Mazda used roughly the same tuning system on the turbo engine as
they used
on the no turbo engine. Roughly around 20 to 28 inches.
The iron is wider on the three rotor because one intake port is
wider than
the ones used in the 2 rotor center iron. However some people
are building three rotor with custom shafts that use the two rotor
center housings.
Works best with p-ports as the side intakes are not used.
Paul Lamar ...No rotor no motor.
Paul, Who is building the E shafts for the fabricated 3 ?
Maybe they'd like to build alum irons too. Thanks, Dave
It was Guru Racing in Australia but as I understand it they are out of biz.
I am not sure about that. Perhaps our Aussie friends can fill us in.
There are some people in Japan building four rotor shafts I think.
Mazdaspeed the racing parts arm of Mazda USA is still selling three rotor
shafts to support the racing effort. They probably have 3 rotor center housings
as well and other three parts as well. There are some people on here that can
get parts from them.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.