Subject: P-Port Renesis Housings
From: Rotary Engine
Date: 6/9/2008, 4:49 PM
To: AAA Put this in the To box






   I watched the F1 race in Montreal this weekend. The top RPM shown on TV
   indicated 19,000 RPM that is for most of the cars.

   On the personal side. If Mazda is capable of producing a PP B26
   running it for 24 hours. Then one should not be concerned if a PP
   engine will or will not work. It has already been done. It is only a
   matter of adjustments not a waste of time.

   Marc Joseph



   One would not want to replace their engine after every flight though.
   Higher RPM means lower life. What you need is a cost per HP per hr. This
   is where the rotory shines because cost to rebuild is low.

   Daniel Michaels

   Nobody has worn a rotary engine out in an aircraft yet.
   The internal failures have been due to FOD for the most part.
   Wear per se does not appear to be a problem.
   Especially when using ceramic apex seals.

   --
   Paul Lamar ...No rotor no motor.


My point was trying to compare a race engine running @ 19,000 RPM for 24
hrs to an engine running 7,000 rpm for 2,000 hrs. They will run at
19,000 rpm but they also get torn down. Yes it works but it will not for
2,000 hrs.  So I do not know how that equates to an engine running 7,000
RPM but running for 2000 hrs.

Dan

Piston engines and rotaries are apples and oranges. F1 piston engines are
good for only two races.

Mechanisms that reciprocate generate reversing loads. Reversing
loads lead to reversing stresses. Reversing stresses lead to
metal fatigue and limited life. The Wankel rotary engine has no
reversing stresses therefor the life of the major parts such as the
eccentric shaft and rotor are unlimited unlike crankshafts, connecting
rods, pistons and poppet valves.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.