Subject: P-Port Renesis Housings
From: Rotary Engine
Date: 6/9/2008, 4:54 PM
To: AAA Put this in the To box



That is correct Paul.  We were able to produce 180+ horsepower at 5500 rpm
on early engines using smaller diameter 1 9/16" diameter runners shown in
our "out-across-over and back" configuration from the plenum to the
peripheral ports which you show in some of your photos.  Subsequent engines
used larger diameter intake runners of same length for higher h.p.  Per your
notes, all our experience correlates to published Mazda data.  For length,
we basically used the longest runner length we could reasonably fit in the
RV-3 and 4 cowlings. We tested many different diameter and length
combinations on the dynos.

Regarding carbs, on the prototype Powersport engines we did test fly a
Weber/Holly carb and tested Mikuni carbs on the dyno on the first engine but
these made less power and tractability was not as good (such as on short
final approaches and other changes in throttle setting) than our first fuel
injection system which had a homemade servo and the rest Hillborn based fuel
injection pieces  in the constant flow system.  Subsequent engines all used
constant flow fuel injection with a venturi that Evertt designed for the
plenum inlet for signal and Don Rivera's Airflow Performance fuel-servo
controller which worked flawlessly.  When we used direct injection in the
rotor housings we used vented nozzles which Don supplied.  These were vented
back in to the induction tubes.  When we went to nozzle locations outboard
of the throttles we could use unvented nozzles.

Your photos show the above configuration with linkage inter-connect to the
throttles and controller/servo.  This is the same system we built for the
current airplane not yet flown and Don has all the pieces now to test and
callibrate the controller.

Recommend Dave contact Don Rivera on automotive applications as well.  Don
is a great guy and protege of the guy who designed and developed the
original Bendix fuel injection system.  Don is a gold mine of expertise with
experience as far as I know the only manufacturer with extensive expertise
on both aircraft and automotive engines--both rotary and reciprocating
engines.  Sean Tucker and other top sticks all use his stuff.

Don't know what effect placing our throttles in the port insert in the rotor
housings; that was the only configuration we ever tested on our peripheral
port engines.  The first engine in 1988 used prototype dual side ports
(aluminum housings) with 14 and 16" runners (were too short) from a plenum
atop engine with throttles/shafts mounted in intake tubes leading to plenum.
This engine made 200  hp @ 7,000 and that is what led us to configure all
subsequent engines with peripheral ports which were a lot smaller and more
conservative than race car engines and modest sized, long runners to develop
rated power at low rpm.  Up to that point we knew of no high performance
automotive rotary engine builders doing anything similar to this
configuration and such low target rpm and horsepower combination.

Steve Beckham

Steve,
I am doing a single rotor PP about the same size and was wondering what
length runner you settled on for 6,000 rpm.
George (down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.