Subject: Exhaust noise
From: Rotary Engine
Date: 6/10/2008, 11:12 AM
To: AAA Put this in the To box


   Steve,
    >> A system to redirect exhaust pulses without restricting the
   exhaust gases
    >> is
    >> definitely the answer and is easily achievable. I have also
   incorporated
    >> an
    >> internal cooling tube and external cooling outer case, with a duel
    >> augmentation. The trick here is to calculate that the cooling
   air doesn't
    >> restrict the exhaust outlet. So I have cooling air tube
   augmentation
    >> (which
    >> cools and helps extract the exhaust gases) and the exhaust gases
   sucking
    >> in
    >> outside cool air (further cooling the exhaust gases).
    >>
    >> The theory of this muffler is -as the exhaust pulse scrubs
   against the
    >> mufflers inner surface the pulse noise will turn into heat. Then
   you need
    >> to
    >> remove the heat. The outside case serves as a heat barrier as well.
    >> I think I have all the bases covered - what do you think Steve.
   Do you
    >> and
    >> Lynn want a drawing. Remember it will be a bit heavy and cost
   $200 for
    >> parts - if you buy off the shelf. Mine is still at the welders
   so it is
    >> untested as yet. I did include a reflector plate on the opposite
   side of
    >> the
    >> exhaust header tube outlet and wondering now if I should have !?
    >> George (down under)
    >
    >
    > George--yes, any configuration drawing or photos you have would be
    > appreciated.
    > Regarding introduction of additional external cooling air for
   mufflers, it
    > was avoided.
    > Thermodynamics aside, it adds to the overall cooling drag that is
   produced
    > by introducing air to cool heat exchangers, blast air to cool
   electrics,
    > or
    > other .  It all adds up and the total of all  internal/cooling drag
    > sources,
    > reduces efficiency and slows you down.
    >
    > And if packing if used instead between the inner and outer shells
   for
    > either
    > noise attenuation and/or damping, we could never keep material
   from being
    > pounded to dust.
    > This included some fairly intricate ceramic blanketmaterials.
    >
    > We did fabricate a .016 stainless shell around the exhaust tubes
   out of
    > the
    > exhaust ports.  This served two purposes.  This stainless shell
   was to
    > keep
    > from heating air contacting exhaust tubes at the hottest section
   out of
    > ports...before it passed through the water heat exchanger(s) located
    > behind
    > the engine.   Shell sections were secured by nutplates installed
   on 90
    > degree stainless sections held by the flange nuts securing the
   four stud
    > exhaust flange.
    >
    > The other purpose of this shell was to hopefully provide a small
   safety
    > margin to buy some time in the event of a failure at the flange and
    > exhaust
    > tubes coming out of the ports and turning the corner.
    >
    > Steve Beckham


I would like a picture. Thank you.

Lynn E. Hanover



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.