Subject: Exhaust noise
From: Rotary Engine
Date: 6/10/2008, 5:31 PM
To: AAA Put this in the To box


Matt--yes, we transitioned to slip joints exclusively except for the later
style ball joint at the port on last engine.  Slip joints were simple, cheap
and worked great.  After transitioning away from an exhaust manifold, on
second system we welded simple little stub stacks no more than an inch long
to the exhaust flange then  a slip joint over that with exhaust pipe and
good quality stainless safety wire to tabs each side for retention. Worked
great but looked a little cheesy and did not address movement about the axis
of the engine centerline. But we simply isolated the entire system near off
the engine mount or fuselage with thin steel strapping held to exhaust with
stainless clamps, then rubber isolators each side of the strapping where it
attached to engine mount or fuselage.  The thin spring steel strap was bent
like an upside down "u" with the sides angled out and horizonal legs where
the clamps went.  The spring steel allowed movement and kept heat away from
the isolators.  From that system we later went to the more robust all-axis
port ball joints which Paul has shown.  A lot tricker but a lot more work
also.

Steve Beckham

Steve,
They looked to be pressed out of 3/16" material - is that correct?
George (down under)

I think you might be able to buy those joints from racing outfits.
Here is some McMaster parts that might be adapted.
The .065 wall is about right for holding up under the rotary temps.

Paul


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.