On Tue, Jun 10, 2008 at 9:26 AM, Rotary Engine <rotaryeng@earthlink.net> wrote:
Steve, here are a couple of beauties.
One crashed in a vineyard in N. Cal. when a automotive master switch
vibrated apart and the EFI/IGN quit.
Supposedly it is being rebuilt.
--
Paul Lamar ...No rotor no motor.
http://www.ntsb.gov/ntsb/brief.asp?ev_id=20051011X01613&key=1
Another case where the "auto engine" wasn't at fault...
The "aero engine" guys have an advantage because they can just copy
what's in a Cessna or Piper and achieve the same (though not perfect)
reliability.
Matt-
Actually, I just re-read the ntsb report.. I think they ran out of
gas and blamed the engine quitting on the failure of the switch.
Matt-
"The experimental airplane collided with grapevines and support posts during a forced
landing following a loss of engine power while on downwind for the runway. The pilot
performed prelanding checks on downwind, and upon switching on the second fuel pump,
the engine lost power. The pilot switched the fuel pump to the original position and
selected the other fuel tank. Neither action caused the engine to regain its power.
The pilot attempted to lower the electrically powered flaps to prepare for the emergency
landing on the runway but the flaps failed to deploy. The airplane carried an excess
of 30 to 40 knots while flying 10 to 20 feet above the runway; the pilot determined
that he would easily overrun the 2,480-foot-long runway and impact structures at the
end if he did not divert the airplanes path. He pulled up and turned left 180 degrees
to dissipate the extra energy and landed along the vine rows of the neighboring vineyard.
First responders reported that there appeared to be no fuel in the airplane's fuel tanks
nor evidence of a post accident fuel spill or leak from the airplane. The pilot said that
the airplane's electrical system powers the engine's electronic ignition, propeller pitch
control, and flaps. Examination of the electrical system revealed that the "Master Power Switch"
that was being used was an automotive keyed single pole single throw switch, and that
the back was loose and coming apart, making the internal electrical contacts intermittent.
This switch ties together power from the batteries and the alternator. Failure of
this switch could result in the loss of ignition power to the engine.
The National Transportation Safety Board determines the probable cause(s) of this
accident as follows: a loss of engine power due to the failure of the master electrical
power switch, which removed power to the electronic ignition."
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.