Subject: Stronger than steel
From: Rotary Engine
Date: 6/10/2008, 11:14 AM
To: AAA Put this in the To box


-
W/ even stronger papers.. the sky's the limit :-D

Google should point it out the article..

Jarrett Johnson

I wonder how long it will be before we see it incorporated with
fiberglass
as a composite system?
George (down under)

I'm sorry. I'm confused. Are we talking about the paper
as a honeycomb for the inside of the sandwich
or the paper as a skin with something like foam
on the inside?
-Jeff Martin

Jeff,
I don't know, perhaps both could be possible, initially I believe they were
talking about core material with fiberglass outer.
George ( down under)


Paper is basically a felt-like material made of cellulose fibers. Isolated
cellulose fibers are very strong, not far behind glass, but "stonger than
steel" is pushing it a little. Plain paper, or "cellulose felt", by itself
is pretty limited as a structural material, but can serve very well as the
fiber component of a composite. Just add epoxy to cellulose felt and you get
a composite almost as good as fiberglass, as Molt Taylor demonstrated years
ago.

Several years ago, I did some experiments using laminated paper towels as
the source of cellulose and made large sheets of "cellulose composite",
using Aeropoxy as the resin. The result was not quite as good as the best
fiberglass composite, but didn't miss it by much. I saw it as potentially
useful in making small, non-structural, complex shapes like wing strut
fairings, access doors, etc. One technique might be to use small pieces of
wetted paper like "papier machie" (pardon the spelling), the way pinatas are
made, to form a useful part.

I did not use my "cellulose composite" sheets as skins to make cored
sandwiches, though it was obvious that such sandwiches would be quite good.
Glass skins are lighter and tougher, so I stuck to glass.

Cellulose fiber is good stuff, though, and has its place. Molt Taylor was
right. Any composite builders in the crowd: Try it! Next time you have a
little wet epoxy left over, put two or three layers of paper towel on a
sheet of plastic, pour the epoxy on, fold the plastic over, squeegee it
around, and let it cure. The result may surprise you.

Zeke Smith


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.