George--intake runnerlength was 24 to 25 inches total including length of
peripheral port inserts and effective length of plenum stub tubes including
the bell inlet...i.d of tube 1 11/16"  for rated power at 6,000 rpm.

Steve Beckham

Steve,
I see what you mean.
On another point did you build up the inlet area and does that inlet shape
carry through to the inside, I assume it does.I've done similar designs
myself but consider it to be more work than necessary compared to round.
I also asked about the inlet tube length. Mine will be 43mm ( 1.7")diameter
and I was wondering what length you finally settled on for 6,000 rpm.
George (down under)

Steve, Thanks I needed that info!

Paul, these should work, their in Paint.
I must have been doing something wrong, as usual, I know!
I have attached a photo of the component count of the VAM, could
you include it with the drawings, I have just sent.
George ( down under)

No dwgs came through.

Paul Lamar



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.