Subject: rotary exhaust muffler
From: Rotary Engine
Date: 6/11/2008, 9:23 PM
To: AAA Put this in the To box


Paul, Has anyone used an expansion chamber as on a 2 stroke motorcycle
engine on a rotary?

Not that I know of. Are they empty inside?
-- Paul Lamar ...No rotor no motor.

Yes Paul the 2 cycle expansion chamber is open inside.
They work on a diverging cone followed by a converging cone.
The idea is to accelerate the flow through the cylinder to the
point that the fresh charge starts to flow out the exhaust port,
and then a reflected wave bounces it back in. They need a truly
diverging header to work the best. The exit is often placed in
front of the converging cone by having a tube inside and also
sticking out the back a little. I've seen examples where the
converging cone is actually closed and the exit pipe sticks out
the side of the chamber. That is most common on the Kart engines.
These are NOT MUFFLERS! They are loud as hell. These are TUNING
devices and have one of the most annoying barks you will ever hear.
They have probably been tried on the rotary. The old RX-2 sedan
racing exhaust was a 2 into 1 megaphone with the megaphone exiting
below the passenger door. It was so loud that it would make you sick
if you were in front of it for too long!
Bill Jepson



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.