Subject: Powersport PP
From: Rotary Engine
Date: 6/12/2008, 9:32 PM
To: AAA Put this in the To box


Steve Beckman,
I have found an old Powersport performance Graph, which shows corr.HP
245 HP and corr. Torque 195 ft lbs, for the PP with 24.5" length runners
and a 58mm Weber carb ( at 7,200rpm) - is that a duel throat carb?

A single throat 58mm doesn't sound big enough for a 2 rotor and over
kill for a single rotor.

I have opted for a 43mm inlet with a 43mm slide carb with no venturi for
a single rotor with high compression RX8 rotor with 3mm apex seals and
hoping for 115 to 125 hp.
George (down under)


That is the data we got on the Mazdatrix dyno. Not Power Sport.
The temporary 58 mm Weber is a dual throat. We could not get Tracy's EFI system
tuned in the limited time we had on the dyno so we installed the Weber.

The runners were 2 inch OD and .065 thick wall  with a 1 7/8 inch ID. We copied
the Mazda Lemans engine runner length, timing and runner OD and ID.
This correlated well with the Lemans engine HP and torque given the differences.

There is now a Teflon slide throttle on it. No butterflies. Mark Suspinski
owns it and it is installed in his Mustang II. It first ran with EFI about
July 2007. It now has Tracy's EFI/IGN system.

Here is a chart of Mark's engine and a chart of Marks's engine and the late Power Sport
engine.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.