I just invented a cheap book shelf that is ten times stronger and
stiffer
than a plain wood book shelf. It matters not if the 20 gage (.020 thick)
steel sheet is glued to the 3/4 birch ply on the bottom or the top.
Do you want to know how it works?
Google neutral axis of beams.
The neutral axis of the beam is moved towards the high strength and
high stiffness
cheap 20 gage steel sheet.
--
Paul Lamar ...No rotor no motor.
What kind of glue Paul? And just sandpaper the metal
surface? Thanks, Dave D.
Construction adhesive in tube and applicator.
No sanding. The shear stress apparently is minimal.
Might make a good 1/2 inch thick Schertz beam if it will
withstand the heat. You would need no spacers for the pan bolts
or anything other than a hole for the Barry rubber bushings.
I would use the thinest 4130 steel sheet on both sides of a 1/2 inch
thick Oak board you can buy. 0.025" would be plenty thick enough.
Probably need 300 F epoxy.
I designed a "Modified" (now called "Late Model") space frame race car 30 years ago for
Steve Smith Autosports using thin mild steel on both sides of 3/4 plywood for
the firewall. It was so stiff you could hang the brake pedals and brake cylinders
off it with no reinforcements. Handy. Hundreds if not thousands were built as
Steve Smith sold plans for years and years.
It would also make a good aircraft firewall too if you used thin .016"
stainless steel on both side of 1/4 inch ply.
The fabricator had a 44 Magnum long barrel revolver. He wanted to
see what would happen if he fired a bullet at it point blank range.
The purpose was to see if it would function as a light weight clutch scatter shield.
The bullet was captured in the firewall and did not completely penetrate.
Verified the term "bullet prof" when applied to race cars :)
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.