Paul,
Have you seen a drawing of the torque peak-trough profile for a 4
rotor. I would think you'd want to clock the e-shaft between the two
engines so that it is "even fire" (each firing event the same amount
of angular rotation from the previous) and further so that it doesn't
have a rotor firing at the same time as any other. Does that sound
right?
Regards,
Matt-
The first two are 180 degrees apart and the next two are clocked
90 degrees and 180 apart. This four rotor balance diagram
illustrates that fact. I don't have a torque variation chart
scanned but it is probably equivalent to a V8 only smoother
in the same way a two rotor is smoother than a four cylinder.
--
Paul Lamar ...No rotor no motor.
Thanks! That's a good one.
I was looking for something like what's depicted here:
http://www.epi-eng.com/piston_engine_technology/torsional_excitation_from_piston_engines.htm
I have a suspicion that the torque profile should be like a 12cyl even
fire but haven't tried to work out whether the 4 rotor is an even fire
also.
I believe the 2 rotor is like the 6cyl even fire for torque.
Matt-
The 2 rotor is the same as a four cylinder.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.