> What takes powder coating off of 4130 tubing? Besides dynamite.
> Dave D
>
> A sander? Sand blasting? Paint stripper?
> --
> Paul Lamar ...No rotor no motor.
>
> NITRO.
>
> Bill Jepson.
The mere mention of nitro reminded me that the major source comes from
China.
They stopped shipping recently, and will not allow transport within or out
of
their country until some time after the Olympics.
Anyone holding amounts of it, at present, has the ability to gouge racers in
need.
Another sad state of affairs.
Archie
Common methyl cloride stripper will remove it. They have it at Home Depot.
Steve Brazil
Folks, please do not use any of the following ideas regarding stripping
powdercoat. The best and easiest way is to go to AutoZone and buy a can of
Aircraft Stripper. It is available very inexpensively and all you need is to
apply it and put it in the sun for 20 min or so then scrap it off with scrapper
or wire brush. CAUTION It is VVERY CAUSTIC. Make Sure you use Nitral gloves and
have plenty of soapy water available to rise. Stuff works incredibly well. There
is nothing else that will work.
Good Luck, Doug Mueller
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.