Subject: Fish tail mufflers
From: Rotary Engine
Date: 6/15/2008, 12:54 PM
To: AAA Put this in the To box



Here is another fail safe design. The Brits invented it almost
100 years ago. It was used on Brooklands race cars. It is called
the Fishtail muffler.

The flat panels must be beefed up or they will resonate and crack.

The last one is a tuned tangential with Fishtail.

Paul Lamar ...No rotor no motor.


Ed Anderson tried a fish tail muffler on his RV 6 about 5 years back.
Said it disintegrated within a couple of flights. I don't remember
whether he reinforced the panels though.

Mark Wrathall

Ed just squashed the exhaust pipe flat. See the last two jpg's.
That is not a true fish tail muffler as the exit area is reduced
compared to the cross sectional area of the exhaust pipe.
That speeds up the exit air velocity and adds more back pressure.

Also it was not reinforced and one or more designs
had holes drilled near the squashed ends.
Consequently it failed where the pipe was over stressed in the bend and
the flat parts probably resonated.

Hi Paul,

The graph shows a little more than 1/2 the pressure wave.  Say it's
half, would that represent 3 or 6 db in sound reduction?  I would guess
6 as using an electrical analogy, lb/in2 seems more like voltage than
power.

Do you have a drawing of the box they referred to in the graph?  I was
wondering if it was configured like the tangential or if it was at the
end of an exhaust pipe.

Thanks,
Bob W.

-- 
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://roblinstores.com/cables/

I am not sure how peak pressure relates to peak noise power  but - 3 db is supposed to
be half the noise power.

BTW Several people have used exhaust ejectors AKA exhaust augmenters instead of mufflers.
I think the Cessna 310 had them. Also this rotary powered Velocity. I don't think it had
a muffler hiding inside. If you release the noise in a wind tunnel it won't sound as loud :)
More benefits are a bit of thrust and better cooling air flow at low to medium speeds.


2715. Acker, Loren W Kleinknecht, Kenneth S , ***Flight comparison of
      performance and cooling characteristics of exhaust-ejector
        installation with exhaust-collector-ring installation ,
        <http://naca.larc.nasa.gov/reports/1947/naca-rm-e6l13a/>* NACA
        RM-E6L13a , February 14, 1947 , pp. 37 .

We have this one.
2259. Manganiello, Eugene J Bogatsky, Donald , ***An experimental
      investigation of rectangular exhaust-gas ejectors applicable for
      engine cooling ,
         <http://naca.larc.nasa.gov/reports/1945/naca-report-818/>* NACA
        Report 818 , 1945 , pp. 19 .


We have this one too. Not very relavent.
4694. Fred D. Kochendorfer and Morris D. Rousso, ***Performance
        characteristics of aircraft cooling ejectors having short
        cylindrical shrouds,
        <http://naca.larc.nasa.gov/reports/1951/naca-rm-e51e01/>* NACA RM
        E51E01, May 1951, pp. 41.


4760. Ellis, C. W., Hollister, D. P. and Sargent, A. F., Jr.,
        ***Preliminary investigation of cooling-air ejector performance at
        pressure ratios from 1 to 10 ,
        <http://naca.larc.nasa.gov/reports/1951/naca-rm-e51h21/>* NACA
        Research Memorandum E51H21, 1951, pp. 23.

5399. Greathouse, W. K. and Hollister, D. P., ***Preliminary air-flow
      and thrust calibrations of several conical cooling-air ejectors
        with a primary to secondary temperature ratio of 1.0 I :diameter
        ratios of 1.21 and 1.10 ,
        <http://naca.larc.nasa.gov/reports/1952/naca-rm-e52e21/>* NACA
        Research Memorandum E52E21, 1952, pp. 26.

5433. Greathouse, W. K. and Hollister, D. P., ***Preliminary air-flow
      and thrust calibrations of several conical cooling-air ejectors
        with a primary to secondary temperature ratio of 1.0. II :diameter
        ratios of 1.06 and 1.40 ,
        <http://naca.larc.nasa.gov/reports/1952/naca-rm-e52f26/>* NACA
        Research Memorandum E52F26, 1952, pp. 35.

6401. Huntley, S C Yanowitz, Herbert , ***Pumping and thrust
        characteristics of several divergent cooling-air ejectors and
        comparison of performance with conical and cylindrical ejectors ,
        <http://naca.larc.nasa.gov/reports/1954/naca-rm-e53j13/>* NACA
        RM-E53J13 , January 20, 1954 , pp. 44 .



I have several of these pdf's. The best is 818.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.