> What takes powder coating off of 4130 tubing? Besides dynamite.
> Dave D
>
> A sander? Sand blasting? Paint stripper?
> --
> Paul Lamar ...No rotor no motor.
>
> NITRO.
>
> Bill Jepson.
The mere mention of nitro reminded me that the major source comes from
China.
They stopped shipping recently, and will not allow transport within
or out
of
their country until some time after the Olympics.
Anyone holding amounts of it, at present, has the ability to gouge
racers in
need.
Another sad state of affairs.
Archie
Common methyl cloride stripper will remove it. They have it at Home
Depot.
Steve Brazil
Folks, please do not use any of the following ideas regarding stripping
powdercoat. The best and easiest way is to go to AutoZone and buy a
can of
Aircraft Stripper. It is available very inexpensively and all you need
is to
apply it and put it in the sun for 20 min or so then scrap it off with
scrapper
or wire brush. CAUTION It is VVERY CAUSTIC. Make Sure you use Nitral
gloves and
have plenty of soapy water available to rise. Stuff works incredibly
well. There
is nothing else that will work.
Good Luck, Doug Mueller
Everyone reads their labels, right ? Zip Stip and many similar products
are Metholine Chloride.... works very very good. Its not corrosive, but
not good for your health, so wear the gloves.
-dave
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.