Paul,
I have used Be-38AL alloy that is now sold as AlBeMet162 by BrushWellman.
The following link will give you very good material properties data.
http://www.berylliumproducts.com/Attributes.aspx?id=AlBeMet162
The main issue would be wear in the apex seal and corner seal areas (would
need a hardened insert). The side clearances would also have to be looser,
as this grows more than cast iron. On the up side, the coefficient of heat
transfer is very good. This would make charge cooling more effective for
those engines, and oil cooling more effective on mazda style.
And boy would these be expensive parts.....
Although.... it tig welds very nicely, so a multi part rotor could be made
and welded together.....
Anyone with a big pot of money? :)
Larry
Agreed and all good observations. Not something we can do but certainly
within what Mazda can do. Thanks also for the fabrication tips.
--
Paul Lamar ...No rotor no motor.
Larry,
So roughly, how much cost in material alone in a rotor, just out of
curiosity.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.