Subject: Higher power for your rotary.
From: Rotary Engine
Date: 6/17/2008, 10:17 AM
To: AAA Put this in the To box


> Paul,
> I have used Be-38AL alloy that is now sold as AlBeMet162 by
BrushWellman.
> The following link will give you very good material properties data.
>
> http://www.berylliumproducts.com/Attributes.aspx?id=AlBeMet162
>
> The main issue would be wear in the apex seal and corner seal areas
(would
> need a hardened insert). The side clearances would also have to be
looser,
> as this grows more than cast iron. On the up side, the coefficient of
heat
> transfer is very good. This would make charge cooling more effective for
> those engines, and oil cooling more effective on mazda style.
> And boy would these be expensive parts.....
> Although.... it tig welds very nicely, so a multi part rotor could be
made
> and welded together.....
>
> Anyone with a big pot of money? :)
>
> Larry
>
> Agreed and all good observations. Not something we can do but certainly
> within what Mazda can do. Thanks also for the fabrication tips.
>
> -- > Paul Lamar ...No rotor no motor.

Larry,
So roughly, how much cost in material alone in a rotor, just out of
curiosity.
George (down under)

It should also be mentioned that most  Beryllium products emit
toxic gasses when heated. Maybe the alloy is less dangerous?
I know some technicians that nearly killed a famous motorcycle
rider when they made some brake rotors from beryllium. The
repeated inhalation of the vapors can cause a material specific disease
berylliosis. Again maybe the dangers are reduced or eliminated
in the alloy.
Bill Jepson

Was it gas or was it dust?

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.