Subject: Higher power for your rotary. Maybe a breakthrough???
From: Rotary Engine
Date: 6/18/2008, 11:51 PM
To: AAA Put this in the To box



What amazes me the Brits were using WW II era RR58 aluminum alloy pistons
up until about 1997 for engines turning 14,000 RPM.
With oil spray for cooling. Earlier Formula 1 turbo charged
pistons used an oil gallery built into the piston
for cooling. Oil pressure was sent up the (probably titanium) connecting
rod, through the piston pin and into the oil gallery.

The same approach could be used in the rotary.
Instead of squirting the oil up inside the aluminum alloy rotor
the cooling oil could be fed through the rotor bearing
into a matrix of oil galleries inside the rotor.

X2020-T6 would have been a better choice than RR58 IMHO.


Paul Lamar ...No rotor no motor.

Paul,
Good idea and is already being successfully done up to a point.

As the single rotor has difficulty having sufficient space for an oil jet
like the two rotor, some are drilling a hole in the centre of the rotor to
take the rotor cooling oil directly from the bearing supply hole of the
e-shaft.
There could be 3 holes drilled one facing the centre of each rotor face, if
necessary, keeping the hole size small so that it doesn't starve the bearing
lubrication.

Can't see why this system couldn't be used in a lightened rotor.
George (down under)

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++


This relatively recent development is REAL promising.


Quote:
NASA Marshall Space Flight Center - Huntsville, AL
Revision Date: 01/18/2007
Information : High Strength Aluminum Casting Alloy for High Temperature Applications

A hypereutectic alloy such as A390 is a conventional aluminum alloy used to make pistons
in U.S. automotive engines. This alloy has adequate strength, is easily cast, and is
low in cost.

However, a typical alloy such as A390 aluminum alloy used in the design has inadequate
tensile strength in the required 500° to 600° F temperature range.

In 1995, Marshall Space Flight Center’s (MSFC’s) metallurgists began working with Ford
under a Space Act Agreement to develop a new, castable aluminum alloy that had a 30%
improvement in tensile strength during operation in the required temperature range.
The result was an aluminum-silicon alloy that meets or exceeds all original automotive
criteria. Figure 3-3 shows a 600° F, tensile strength comparison of available aluminum
alloys against the NASA alloy. The projected cost of the aluminum-silicon alloy is 95¢
 per pound versus 87¢ per pound for A390. Since less of the new alloy material is required
due to its higher strength, the cost per piston is expected to be comparable. MSFC has currently
filed a patent on the aluminum-silicon alloy, and negotiations are ongoing with Ford and
other U.S. automobile manufacturers regarding its use.

End of quote.

No details yet of the percentages of different materials in the alloy.
600 F will work fine for a rotor with internal oil cooling and steel inserts
for apex seal slots. The rotor might weigh about half of the current 9 pound
iron rotor so RPM might be 1.50 higher or about 16,500 RPM. HP might be as much
as 480 for a NA P-port two rotor and 720 HP for a three rotor. It will be
a lot cheaper than BeAl alloy.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.