Subject: Higher power for your rotary.
From: Rotary Engine
Date: 6/18/2008, 3:16 PM
To: AAA Put this in the To box


What amazes me the Brits were using WW II era RR58 aluminum alloy pistons
up until about 1997 for engines turning 14,000 RPM.
With oil spray for cooling. Earlier Formula 1 turbo charged
pistons used an oil gallery built into the piston
for cooling. Oil pressure was sent up the (probably titanium) connecting
rod, through the piston pin and into the oil gallery.

The same approach could be used in the rotary.
Instead of squirting the oil up inside the aluminum alloy rotor
the cooling oil could be fed through the rotor bearing
into a matrix of oil galleries inside the rotor.

X2020-T6 would have been a better choice than RR58 IMHO.


Paul Lamar ...No rotor no motor.


The nice thing about the way the rotor is cooled now is the spray is
directed around the rotor as the eccentric shaft spins in it. Oil nozzles in
the rotor would be very directional. Although that could have benefits as
well.
Larry


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.