What amazes me the Brits were using WW II era RR58 aluminum alloy pistons
up until about 1997 for engines turning 14,000 RPM.
With oil spray for cooling. Earlier Formula 1 turbo charged
pistons used an oil gallery built into the piston
for cooling. Oil pressure was sent up the (probably titanium) connecting
rod, through the piston pin and into the oil gallery.
The same approach could be used in the rotary.
Instead of squirting the oil up inside the aluminum alloy rotor
the cooling oil could be fed through the rotor bearing
into a matrix of oil galleries inside the rotor.
X2020-T6 would have been a better choice than RR58 IMHO.
Paul Lamar ...No rotor no motor.
Paul,
Good idea and is already being successfully done up to a point.
As the single rotor has difficulty having sufficient space for an oil jet
like the two rotor, some are drilling a hole in the centre of the rotor to
take the rotor cooling oil directly from the bearing supply hole of the
e-shaft.
There could be 3 holes drilled one facing the centre of each rotor face, if
necessary, keeping the hole size small so that it doesn't starve the bearing
lubrication.
Can't see why this system couldn't be used in a lightened rotor.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.