Subject: Higher power for your rotary. Maybe a breakthrough??? Correction
From: Rotary Engine
Date: 6/19/2008, 8:05 PM
To: AAA Put this in the To box


Paul,
A Ti rotor would probably now be possible by using DLC coatings in all the
seal grooves to prevent galling. It can also be investment cast very
accurately.
Just out of curiosity, do you know if anyone has tried DLC on the side
housings? Wouldn't be cheap, but the stuff is hard and slippery. Some racing
connecting rods are now being built without wrist pin bushings by DLC
coating the wrist pin. Also used on many racing flat tappet cams, and that
is an extreme high pressure area known for failure.
Larry

Larry,
Your right Titanium doesn't wear well but DLC on the side housings would
only be good if the substrate is strong - with most aluminium it isn't. What
is required is a denser stronger aluminium. That's why det-gun coatings are
good as they introduce depth of hard material.
Without depth, the best of all possible surface finishes, fail as the
sub-strate fails.
I am probably preaching to the converted here, but I included this info for
those who might not know. It is interesting that Mistral has tried all the
high tech surface treatments and they all failed until they identified a
more dense substrate.

    ask me what that is, if I told you I would have to kill myself - just
joking, I really don't know, I also didn't ask. I guess it's commercial in
confidence. However sufficient research would most likely come up with the
same or similar solution. As per this current discussion.
Love all this stuff!
George (down under)



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.