Subject: Higher power for your rotary. Maybe a breakthrough??? Correction
From: Rotary Engine
Date: 6/19/2008, 10:35 PM
To: AAA Put this in the To box



   Mazda currently uses DLC on the stock corner seals.
   http://www.rotaryeng.net/history.html

   The side seals IMHO are less likely to gall as there is little or no
   reversing
   of loads. I think all you need worry about is the apex seal slot.

   Is it possible to cast in steel inserts  in titanium castings?

   Paul Lamar ...No rotor no motor.


Paul, Ti will alloy with almost anything. It should be possible to cast
in parts.The real question is will the cast in material weaken the Ti
strength. Even just contact will cause some materials to leach into
titanium at high temperatures. Chrome is particularly bad. Caused a
bunch of trouble on the SR-71 until they figured it out.They had to get
tools without chrome on them. It would require a good matalurgist to
tell you.
Bill Jepson



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.