Paul,
If the new corner seals use DLC, having a nitrided or other hard
material on the side plates becomes very important. Any idea if they
used those corner seals on the LeMans engine?
Bill Jepson
Bill,
Everything I have been told about mating wearing surfaces tells me the
hardest surface wins the wear war. However Larry did say "hard and
slippery", perhaps the slipperiness of the material may off-set the tendency
for higher wear of the side housings.
Then again why is it so slippery - I can only imagine that it is somewhat
porous and holds an oil film.
The small contact area of the corner seal, is the main side housing wear
evidenced in most engines in the past and is the main stumbling block to the
successful development of the aluminum side housings IMHO.
Perhaps then, this development has helped overcome that particular wear
problem - but I'm only guessing.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.